Get a model car cnc'd or printed 3D?

3D Printable Dungeon Tiles & Terrain Forums 3D Printing 3D Printing Get a model car cnc'd or printed 3D?

This topic contains 2 replies, has 3 voices, and was last updated by  RiyuChan 4 months, 2 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #756
    johnsmithsheekha
    Total posts: 6
    Participant

    I would like to get a physical model that I created a 3D car model design. I like it on the 1/10th scale, which is about 20 inches long, 5.5 inches long and 8.5 inches wide.

    As far as materials, I’m looking for cheap, I’m looking for cheap. I think the worst is like polyresin. So where do I get this job? Which method is less costly and how much can I expect to spend on this?

    #761
    Rob
    Total posts: 40
    Keymaster

    If you checkout 3D hubs you can find some pretty good people selling the service of printing your model! Prices vary a lot on there.

    #863
    RiyuChan
    Total posts: 0
    Participant

    You could always go to your local shop that does 3D prints, Im not sure if these are available everywhere but there are a few guys in my area, so if you find something similar just pay them.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.