How to start 3D printing

3D Printable Dungeon Tiles & Terrain Forums 3D Printing 3D Printing How to start 3D printing

This topic contains 3 replies, has 3 voices, and was last updated by  RiyuChan 4 months, 2 weeks ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #783
    Boardie
    Total posts: 11
    Participant

    I’ve been thinking about getting into 3D printing. Where do you suggest that I start looking? I know this is a wide open question. But, I have no experience with any of this at all. I don’t even know where to begin.

    #793
    Rob
    Total posts: 40
    Keymaster

    I would say take a look at tinker cad if you want to make models. If you don’t want to make models and are happy to 3D print some of our models, then I can highly recommend the Anycubic i3 mega as a great beginner printer!

    Good luck 🙂

    #794
    Boardie
    Total posts: 11
    Participant

    Thank you for the response. I’ll take a look at that. This is something that I’ve had an interest in for quite some time. I just haven’t gotten around to actually doing anything about it yet. That’s about to change after finding this forum.

    #860
    RiyuChan
    Total posts: 0
    Participant

    TinkerCard is great for beginners. Do you own a 3D Printer?

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.